Why is DHCP for IPv4 preferred for use on large networks?
Why is DHCP preferred for use on large networks? It is a more efficient way to manage IP addresses than static address assignment.
DHCP reduces the chances of common errors occurring when IP addresses are assigned manually. It also ensures no two hosts can have the same IP addresses. DHCP plays an important role in managing small networks where mobile devices are used and require IP addresses on a non-permanent basis.
IP addresses may identify your own computer, a favorite website, a network server, or even a device (such as a webcam). IP addresses are especially important for sending and receiving information. They route internet traffic where it needs to go, and they direct emails to your inbox.
DHCP is advantageous for network administrators because it removes the repetitive task of assigning multiple IP addresses to each device on the network. It might only take a minute but when you are configuring hundreds of network devices, it really gets annoying.
Dynamic addresses are assigned, as needed, by Dynamic Host Configuration Protocol (DHCP) servers. We use dynamic addresses because IPv4 doesn't provide enough static IP addresses to go around.
DHCP allows users to refer to locations by a name rather than an IP address. Hosts always have the same IP address and are therefore always reachable. Hosts can connect to the network and get an IP address without manual configuration.
DHCP (Dynamic Host Configuration Protocol) is a network management protocol used to dynamically assign an Internet Protocol (IP) address to any device, or node, on a network so they can communicate using IP.
The bytes of the IPv4 is further classified into two parts. The network part and the host part. This part specifies the unique number assigned to your network. It also identifies the class of network assigned.
IPv6 has an address space of 128 bits (which is 4 times larger than IPv4) and can accommodate large no. of devices. It is one of the major reason why IPv6 is preferred over IPv4 but the question is , Is having a larger address space suffice to prefer IPv6 over IPv4?
IPv4 addresses are 32-bit numbers that are typically displayed in dotted decimal notation. A 32-bit address contains two primary parts: the network prefix and the host number. All hosts within a single network share the same network address. Each host also has an address that uniquely identifies it.
Which is better for DHCP addressing?
At Hyper Networks, we get asked all the time: do I need static or DHCP IP? The short answer is that DHCP is usually the best way to go for trade show internet needs. Here's why, how IP addressing works, and when you might need static.
Dynamic IP addresses are cheaper than static IP addresses. They also offer more security and privacy as hackers cannot know what IP address will be assigned to your servers by the ISP. Whatever they may have is guaranteed to change after a while.

No, using static addresses is not magically faster than using DHCP addresses. The goal in that article was to get two PCs on the same physical network segment onto the same IP subnet, so that the router hop could be eliminated from the file-transfer network path.
Since the default DHCP address range is between 100 and 149, you'll want to avoid all of the addresses between 192.168. 1.100 and 192.168. 1.149 when you're assigning static IP addresses. That leaves the ranges from 2-99 and from 150-254 wide open, which is usually plenty for most home networks.
How is a DHCPDISCOVER transmitted on a network to reach a DHCP server? A DHCPDISCOVER message is sent with the IP address of the default gateway as the destination address. A DHCPDISCOVER message is sent with a multicast IP address that all DHCP servers listen to as the destination address.
All depends on your topology really, if you're talking multiple VLANS spanning multiple sites and 1000's of users then I would recommend server DHCP as this would cause unnecessary overhead on your routers and if the router ever goes down then clients will not be able to be assigned IP addresses locally.
Conclusion. There is not better than the other, they serve two entirely different functions, with zero overlap. Both PPPoE and DHCP are critical in connecting to the network, which works to acquire IP address. What distinguishes PPPoE vs DHCP is the methods to obtain IP.